User Manual - Version 2.2 Manual

12 Counterpart User Manual
6. Using the supplied nuts, secure battery pack to enclosure using a 5/16” nut driver.
Figure 2-7. Secure Battery Pack in to Enclosure
7. Run cable over to power plug J12 on the Counterpart CPU board.
Figure 2-8. Connect Power Plug on to J12 on CPU Board
8. Unplug existing power off the CPU board and plug in battery plug J1 on battery CPU.
9. AC plugs into the back of the unit.
Red and green LEDs located on the battery CPU board alert
the user if the battery is fully charged or not.
2.12 Installing Option Cards
Disconnect power cord entirely before installing option cards.
Ethernet port is not suitable for connection to circuits used out
side the building and is subject to lightning
or power faults.
Each option card is shipped with installation instructions specific to that card. For specific
instructions on the WLAN card, refer to Section 8.0 on page 77. 
The general procedure for all option cards is:
1. Disconnect power cord from the scale.
2. Install the plastic standoffs in the standoff holes.
3. Carefully align the option card connector with th
e J14 connector on the CPU board.
4. Press down firmly to seat the option
card in the CPU board connector.
Screw bracket into
enclosure (only one
side shown)
Run cable from
battery pack to J12 on
main CPU board.
Unplug existing power
off the CPU board and
plug in battery plug J1
on battery CPU.
Note