User Manual - Version 2.2 Manual

Counterpart User Manual - Configuration 43
BATCH Off
On
Specifies whether the setpoint is used as a batch (ON) or continuous (OFF) setpoint.
PSHACCM Off
On
ONquiet
Specifiy ON to update the accum
ulator and perform a print operatoin when the setpoint is
satisfied. Specify ONQUIET to update the accumulator without printing.
PSHPRNT Off
On
Waitss
Specify ON to perform a print operation when th
e setpoint is satisfied; specify WAITSS to
wait for standstill after setpoint is satisfied before printing.
PSHTARE Off
On
Specify ON to perform an acquire tare operation
when the setpoint is satisfied. Note that
PSHTARE acquires the tare regardless of the value specified for the REGULAT parameter
on the FEATURE menu.
ACCESS On
Hide
Off
Specifies the access allowed to setpoing parameters shown
by pressing the Setpoint
softkey in normal mode.
ON: Values can be displayed and changed.
HIDE: Values cannot be displayed or changed.
OFF: Values can be displayed bu
t not changed.
DIGOUT None
1-4
Lists all digital output bits available. This parameter is used to specify
the digital output bit
associated with this setpoint. Use the DIGI/O menu to assign bit function to OUTPUT. For
continuous setpoints, the digital output becomes active (low) when the condition is met;
for batch setpoints, the digital output is active until the setpoint condition is met.
SENSE Normal
Invert
Specifies whether the value of the digital output associated with this setpoint is inverted
when the setpoint is satisified.
Table 3-8. Setpoints Menu Parameters