User Manual - Version 2.2 Manual

ManualsBrandsRice Lake ManualsScalesCounterpart Configurable Counting Indicator

Counterpart User Manual - Configuration 47

3.9 Display Menu

There are three display settings on the Counterpart.

Figure 3-15. DISPLAY Menu

Setting the display parameters from this top level menu is temporary - after a power cycle, the values will revert

to their previous values. Changes made to these parameters through the CONFIG menu are kept through a power

cycle.

3.10 ID Menu

The ID menu displays parameters for registers from 1 to 150. Sub-parameters are shown below.

Figure 3-16. ID Menu

DIO 1

DIO 2

DIO 3

DIO 4

STATUS Displays the status of each individual digital I/O port. If set as input, the display

shows input stats IN HI or IN LO. If set as output, pressing Enter toggles the

output between HI and LO. OUT HI or OUT LO. 

OUT LO is active.

PORT1

PORT2

TEST

Performs a loopback test on serial port 1 or 2. Connect jumper TX and RX

together on port 1 or port 2 before testing.

TEST Menu

Parameter Choices Description

Table 3-10. TEST Menu Parameters

ID Menu

Parameter Choices Description

Level 2 submenus

CONTRAST

XXXXXXX

ID DISPLAYTESTSETUPAUDIT CALIBR

BRIGHT IMAGE

100

0-100%

Negative

Positive

SETPTS

REG 1 REG 2

QUANTITY

SAME AS REG 1

CODE DESC

PART NUM LOT UNIT WT TARE

VALUE

VALUE VALUE

OFF

UNITS LOCATION

XXXXXXX

DISPLAYTESTSETUPAUDIT CALIBR

REG 150

SAME AS REG 1

VALUE

SETPTS