User Manual - Version 2.2 Manual

ManualsBrandsRice Lake ManualsScalesCounterpart Configurable Counting Indicator

56 Counterpart User Manual

4. When you have reached the REG number you want to set, press to select that register number.

5. Press and enter the CODE value - either the numeric or alpha-numeric is acceptabl

e. Thirty two

characters can be entered and 25 characters maximum for bar code

entries. This is the code that will be

used to recall the ID.

6. When the desired value is entered, press

TARE(Enter).

7. Enter in the information for descripti

on, part number, lot number, unit weight, tare, etc. with all entries

being optional.

8. Press

TARE(Enter) again to accept the value(s).

9. Press to advance back up to REG. Press one more time, the

DONE softkey is displayed.

10. When complete, push the

DONE softkey.

Enter Lot Number - Optional

1. “LOT” will be displayed. Press key to enter the alpha numeric value using the Counterpart keypad.

2. Press the

TARE(Enter) key to accept.

Enter Unit Weight - Optional

1. “UNIT WT” will be displayed. Press and enter the unit weight value using the Counterpart keypad.

2. Press the

TARE(Enter) key to accept.

Enter Tare - Optional

1. “TARE” will be displayed. Press and enter the tare value using the Counterpart keypad.

2. Press the

TARE(Enter) key to accept.

Enter Units - Optional

1. “UNITS” will be displayed. If you need to adjust the units, use the and keys to adjust the selection or

press to view the current setting.

2. Use the key or the

TARE(Enter) key to store the setting.

Enter Location - Optional

1. “LOCATION” is displayed. Use the key and enter a value. Push the TARE(Enter ) key to store.

5.5.2 Using a Stored ID

1. Press the CODE (softkey needs to be set up) key.

2. Counterpart responds with a code #=> with a

prompt. Enter the ID code.

3. Press

TARE(Enter).

Press code and then enter a zero to unload an ID code.

5.5.3 Clearing ID Codes

1. Press the Menu Setup key.

2. Toggle through menu items to

ID.

3. Select

Reg 1-150 to clear.

4. Push the

Clear ID softkey.

5. The display prompts,

Clear ID Values. Press the Yes softkey.

6. Display shows

ID Cleared.

7. Push the

Menu softkey to return to the Use mode.

Note