User Manual - Version 2.2 Manual

Counterpart User Manual - Serial Commands 69
6.1.6 Normal Mode Commands
The normal mode print commands (see Table 6-12) transmit data to the serial port on demand in either setup or
normal mode.
6.1.7 Unique Commands
Command Description Values
CONSNUM#n Set consecutive number nnnnnnn
UID Set unit ID UID=nnnnnnn
SX#n Start serial port streaming OK or ??
An EX command sent while in menu mod
e does not take effect until the
indicator is returned to normal mode.
The EDP.Stream must be set to LFT or INDUST for this command to work.
EX#n Stop serial port streaming
XG#n Transmit gross weight in displa
yed units nnnnnn UU
where nnnnnn is the weight value, UU is the units.
NOTE: Y
ou can also send XGP, XGS, XGT, XTP, etc. to specify primary,
secondary or tertiary (P.S.T.).
XN#n Transmit net weight in displayed units
XT#n Transmit tare weight in displayed units
XA#n Transmit accumulator value
RS Reset system Soft reset. Used to reset the indicator without r
esetting the configuration to the
factory defaults.
SD Set date SD=MMDDYY, DD
MMYY, YYMMDD, or YYDDMM. Enter six-digit date using
the year-month-day order specified for the DATEFMT parameter, using only the
last two digits of the year.
ST Set time ST=hhmm (ent
er using 24-hour format)
KSOFT1-4 Command to perform function assigned
to softkey
.
n/a
PIECES#n Transmits data from the scale n/a
Table 6-12. Normal Mode Serial Commands
Command Description
DUMPID.INDEX=n To dump an ID by register
DUMPID.CODE=n To dump an ID by code
KDISPMODE Set or request the current display mode. KDISP=COUNT. W
ill switch to that mode. This only temporariliy
switches display. Default is set by dispmode parameter.
Other choices include:
COUNT
WEIGHT
UNIT WEIGHT
Table 6-13. Unique Commands