User Manual - Version 2.2 Manual

Counterpart User Manual - Introduction 3
1.4 Keypad Functions
Key Function
POWER
Turns the Counterpart unit on/off.
NOTE: If the PC1 jumper is set to SW, the POWER button must be used to turn the unit on and off. If the PC
jumper is set to ON, the unit will automatically power on when it’s plugged in and the only way to turn it off is
to unplug power.
Enters Menu mode, allowing configuration if th
e Audit jumper is in the “ON” position. Also used as an
“escape” key in Menu mode.
Sets the current gross weight to zero, provided the amount of weight to be removed or added is within the
speci
fied zero range and the scale is not in motion. The zero band is defaulted to 1.9% of full scale, but can
be configured for up to 100% of full scale.
NOTE: 1.9% is r
equired for legal for trade applications.
Used to enter a known unit weight of a part.
Sends “on-demand” serial information out the serial port, pr
ovided the conditions for standstill are met.
Performs one of several predetermined Tare functions depe
ndent on the mode of operation selected in the
TAREFN parameter. To view a stored tare, see Section 1.5.
Also acts as the ENTER key
Allows the display to change between gross mode and net mode.
This is used for computing the unit weight by sampling.
Press the SAMPLE key after placing a sample on the platform, or after using the numeric keypad to enter the
sample size.
The default sample size is 10.
This switches the weight displ
ay to an alternate unit. the alternate unit is defined in the Setup Menu and could
be kg, g, lb, oz.
Clear key. Used to backspace on entries
Alpha-Numeric
keypad (
see
Figure 1-1)
Used to enter values directly. Press keys for small and upper case alpha characters.
Table 1-2. Keypad Functions
MENU
SETUP
ZERO
UNIT
WEIGHT
PRINT
TARE
B/N
GROSS
NET
SAMPLE
Pieces
UNITS
TOGGLE