Service manual

Installation 3
2.0 Installation
The following sections explain the installation procedure for the CW-90B and CW-90XB bench scales.
2.1 Unpacking Your Scale
Immediately after unpacking, visually inspect the scale to ensure that the unit is undamaged. The shipping carton
should contain the bench scale and this manual. If the bench scale was damaged in shipment, notify Rice Lake
Weighing Systems and the shipper immediately.
2.2 Leveling the Scale
Place the scale in the desired location that is reasonably level and free of unnecessary vibrations and air currents.
Lift off the scale platter and locate the level bubble (See Figure 2-1 for location).
Scale top
Level bubble
location
Jam nuts on scale
feet
Figure 2-1. Top Plate Removed Showing Bubble Level Location
Adjust the four corner feet on the base until the scale reads level and all feet contact the support surface so the scale
does not rock. Lock the jam nuts on the feet when the final level is correct.