Instructions / Assembly

ManualsBrandsRIDGID ManualsPlumbing1 HP Ridgid Stainless Steel Smart Dual Suction Sump Pump

NOTE: Make sure your Wi-Fi and Bluetooth is connected.

1. Download the SmartSumpbyRIDGID App from your device’s app store.

2. Open the SmartSumpbyRIDGID App and click “+ Add Device” to begin device activation.

3. Select your RIDGID® device.

4. Verify that the status LED on the device is blinking yellow. Click Next to continue.

5. Allow access to your devices camera and use your camera to scan the QR code located on the front of your device.

NOTE: Camera will automatically scan QR code when brought into view.

6. After the app “Finds” your device, a network list of local connections will be displayed. Select your network and enter your

password credentials. Click Send.

7. Once connected to Wi-Fi, your device will be registered.

8. The app will now ask for your zip code. By collecting your zip code, we can link your local weather data with your pump

data in the future.

INSTALLATION MANUAL

DEVICE ACTIVATION INSTRUCTIONS

LED LIGHT DISPLAY (CHECK YOUR APP FOR SPECIFIC REAL TIME PUMP INFORMATION)

Color Symptom/Possible Cause(s) Suggested Remedies

Green 1. Good 1. Your pump is good, there is nothing needed

Yellow 1. A clogged pump inlet

2. Electrical voltage or

polarity issue detected

3. Water level in your pit is

not dropping

4. Your motor is showing

signs of aging

1. Open your sump pit and inspect the pump.

Make sure the inlet screen is free of debris and

there is nothing blocking the fow of water into

the pump.

2. Contact an electrician and have them check the

voltage and wiring of the outlet.

3. Check your pump to be sure it is properly

connected. Then check your discharge pipe for

obstructions or leaks that allow water back into

the pit.

4. Consider replacing your pump soon to stay

protected.

Red 1. There is a critical issue

with your pump

1. Replace your pump immediately.

DIGITAL CONTROLLER BUTTON

Function Action to Take

Mute Alarm Short press (at least 1 second)

System Test Hold for 5 seconds (pump health LED will flash blue) and release

Reboot Hold for 10 seconds (pump health LED will flash green) and release

Reset WiFi

Connection and

Reboot

Hold for 15 seconds (pump health LED will flash yellow), release and short

press (at least 1 second) again to confirm

Reset to Factory

Settings and

Reboot

Hold for 20 seconds (pump health LED will flash red), release and short press

(at least 1 second) again to confirm

A Button Hold Legend can be found on the back of the controller for your convenience.