Operator`s manual

Ridge Tool Company
5
SeeSnake
®
microDrain™ Inspection System
Figure 1 – Front View (SeeSnake Configuration)
microDrain System Components
System Cable for
SeeSnake CCU
Camera Head
Shoulder Strap
Case Latch
Camera Clip
Case Latch
Pushrod
Guide
Feet
Rear Case
Front Case
Figure 2 – Rear View (microEXPLORER Camera Monitor
Configuration)
Assembly
WARNING
To reduce the risk of serious injury during use, follow
these procedures for proper assembly.
Camera Head Routing
1. Set the unit on a level surface.
2. Unfasten the case latches on either side of the
microDrain Reel (Figure 4) .
Figure 4 – Unlatching the microDrain Reel Case
3. Open the front case and locate camera head in the
pushrod drum.
4. Route the camera head out through the pushrod
guide in the front of the case and secure it in the pro-
vided clip (Figures 5 and 6) .
5. Close and re-latch the case.
microEXPLORER
Camera Monitor
Slip Ring Module
System Cable for
MicroEXPLORER
Camera Monitor
Case Latch
Feet
Rear Case
microEXPLORER
Camera Monitor
Connector Plug
microEXPLORER
Camera Monitor
Cradle
Cord Wrap
Figure 3 – Inside Case
Camera Head
Case Latch
Removable
Pushrod
Drum
Pushrod