User Guide

Figure 12 – Loosen Cable Bracket
Figure 13 – Removing Cable End
Figure 14 – Removing E-Clips
To Install Replacement Cable
1. Remove two E-Clips, front bearing assembly, and
inner-drum from guide tube shaft (Figure 14 and
Figure 15).
2. Insert approximately two feet of cable through the
guide tube into drum. Let cable follow natural sweep
of guide tube.
Figure 15 – Removing Inner Drum
3. Reach inside drum and grasp cable near end. Po-
sition cable end under cable bracket. Allow 2″ of
cable to protrude past clamp bracket (Figure 16).
Ridge Tool Company 11
K-3800 Drain Cleaning Machine