K-50 Drain Cleaning Machine gress depends upon the sharpness of the tool and nature of the obstruction. WARNING Do not allow tension to build up in the cable. This will happen if the cutting tool hits a snag and stops turning, but the motor and cable continue to rotate. Torque builds until the cable suddenly twists, potentially wrapping around your hand or arm. This can happen quickly and without warning, so proceed slowly and carefully as you feed the cable into the drain.
K-50 Drain Cleaning Machine progress depends on the type of tool being used and nature of the blockage. Advance cable slowly. 7. If cable gets hung up in the obstruction, release the clutch handle to stop the rotation of the cable. Refer to “Reverse Operation” in the “Special Procedures” section. 8. Once obstruction is cleared, it is recommended that operator flush debris from line with running water.
K-50 Drain Cleaning Machine Accessories Tools for C-4, C-6, C-7, C-8, and C-9 WARNING Only the following RIDGID products have been designed to function with the K-50 Drain Cleaning Machine. Other accessories suitable for use with other tools may become hazardous when used on the K-50. To prevent serious injury, use only the recommended accessories. Cables Catalog No. 62225 56782 Model No.
K-50 Drain Cleaning Machine Some of these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia. Avoiding use of these and other types of cleaning agents minimizes the probability of damage. When not in use, store cables indoors to prevent deterioration by the elements. Cables should be replaced when they become severely corroded or worn. A worn cable can be identified when outside of coils become flat. 4.