Install Instructions

K-1500G Drain Cleaning Machine

3. Slide out clutch driver jaws and replace with desired

size jaws.

Figure 12 – Replacing Clutch Jaws

4. Replace nose piece assembly, screws and guard.

Never operate machine with belt guard

removed. Fingers can be caught between the belt and

pulley.

Removing Clutch End Play

1. To remove end play from clutch, loosen screw in

lock and adjusting nut

(Figure 13).

2. Turn lock and adjusting nut clockwise until snug

against body, then back off one half turn.

3. Tighten screw in lock and adjusting nut.

Figure 13 – Removing Clutch End Play

Ridge Tool Company10

Maintenance Instructions

WARNING

Disconnect the spark plug wire before perform-

ing maintenance or making any adjustment.

Moving Parts Lubrication

Grease all exposed moving parts such as rocker arms

and main bearing approximately every three months.

Make sure to grease main bearing through grease fitting

inside clutch handle slot.

Clutch Jaws Lubrication

Clean and lubricate clutch driver jaws with oil after each

use.

Cables

Cables should be thoroughly flushed with water to prevent

damaging effects of sediment and drain cleaning com-

pounds. Periodically lubricate cables and couplings with

RIDGID Cable Rust Inhibitor.

When not in use, store cables indoors to prevent deterio-

ration by the elements.

Cables should be replaced when they be-

come severely corroded or worn. A worn cable can be

identified when outside coils of cable become flat.

Clutch Jaw Replacement

1. Remove three screws holding the front guard to the

housing.

2. Remove two screws from the nose piece assembly

(Figure 11).

Figure 11 – Replacing Clutch Jaws

WARNING