Use and Care Manual

7
ASSEMBLY
Carry Handle
Powerhead
Assembly
#10 x 3/4" Pan
Head Screws (2)
Extended
Flange
Carry Handle Assembly
1. Locate the Carry Handle and the two (2)
#10 x 3/4” Pan Head Screws in loose
parts bag.
2. Position the Carry Handle on top of the
Powerhead Assembly, with the Carry
Handle Extended Flange to the rear of
the Powerhead, as shown.
3. Insert a #10 x 3/4” Pan Head Screw
through the hole at each end of the
Carry Handle and into the Powerhead
Assembly. Tighten securely.
Inserting the Tug-A-Long
Positive Locking Hose with
Dual-Flex
1. Insert the larger end of the Tug-A-Long
Positive Locking Hose with Dual-Flex
into the Inlet Port. Engage the Hose
Latch to the lip of the Inlet Port.
The Hose should snap into place.
2. To remove the Tug-A-Long Positive
Locking Hose with Dual-Flex from the
Vac, press the Release Button on the
Hose and pull the Hose out of the Inlet
Port, as shown.
Powerhead
Assembly
Tug-A-Long Positive
Locking Hose with
Dual-Flex
Release
Button
Vac Inlet
SP7030-1 HD06000 HD09000 2018.qxp_HD0600 HD0900 3/7/18 1:55 PM Page 7