Use and Care Manual

Emptying the Dust Drum
1. Unplug Power Cord from power source.
2. The Vac comes equipped with a Drain
for easy emptying of liquids. Position
the Vac near a suitable drain or
receptacle and remove the Drain Cap.
3. Remove the Powerhead Assembly by
pulling outward at the top of the two
Latches.
4. Lift Powerhead Assembly from the
Dust Drum and set aside.
5. Empty Dust Drum into a proper waste
disposal container.
4. Turn the Vac on and you are ready to
use your Vac as a Blower.
Blowing Feature
Your Vac features a Blowing Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blowing Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Align the Hose Release Button of the Tug-
A-Long Positive Locking Hose with Dual-
Flex End with the Ridges on the Blower
Port. Push the Hose End straight into
the Blower Port until the Hose Release
Button fully engages the Blower Port
Ridges.
3. (Optional) Attach the Extension Wand
to swivel end of the Hose.
WARNING: To reduce the risk
of injury from accidental starting,
unplug power cord before emptying
the drum.
OPERATION
10
D
R
A
I
N
D
R
A
I
N
Drain Cap
Dust
Drum
Drum Latches (2)
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
WARNING: To reduce the risk
of injury to bystanders, keep them
clear of blowing debris.
Extension
Wand
(Optional)
Swivel End of Hose
Blower
Port
Ridges
Tug-A-Long Positive
Locking Hose with
Dual-Flex
Hose Release Button
INSERT HOSE
REMOVE HOSE
1
2
Blower
Port
Ridges
Hose Release Button
1
Remove Hose:
1. Rotate Hose End in either direction to
disengage Blower Port Ridges.
2. Press the Hose Release Button and
pull the Hose End straight out of the
Blower Port.
!
!
!
!
SP7033ESF.indb 10 5/30/18 3:10 PM