Use and Care Manual
14 — English
ASSEMBLY
Fig. 10
SPLASH HOOD
BRACKET
SPLASH
HOOD
LOCK
KNOB
POCKET
SCREWS
INSTALLING THE SPLASH HOOD
See Figure 10.
Remove the bevel table.
Using a Phillips screwdriver, loosen and remove the three
screws located on the pocket under the table behind the
cutting wheel.
Slide the L-shaped splash hood bracket into the pocket.
Reinstall the screws through the splash hood bracket and
into the table. Tighten securely.
NOTE: Align the hood bracket with the cutting wheel so
that it does not interfere with the material being cut. To
check the alignment, see Splash Hood Bracket Adjust-
ment in the Adjustments section of this manual.
NOTE: Always adjust the splash hood horizontally to the
table and slightly above tile thickness. Hood should not
touch the tile.
To lift or lower the splash hood or adjust its position,
loosen the lock knob, adjust the splash hood to the de-
sired height, and retighten the lock knob.
Reinstall the bevel table.
INSTALLING THE RIP GUIDE
See Figure 11.
Place the front of the rip guide on the front rail of the saw
table.
Lower the back of the rip guide to the saw table.
Use the rip guide scale, located on front of the table, to
set the rip guide to the desired width of cut.
Push the locking lever down to secure to the saw table.
When securely locked, the locking lever should point
downward.
RIP
GUIDE
LOCKING
LEVER
Fig. 11