Use and Care Manual

5 - English
FEATURES
ASSEMBLY
PRODUCT SPECIFICATIONS
Size of Paper .......................................................1/4 Sheet
Motion ........................................................... Orbital Action
WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.
WARNING:
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Sanding wood or wood product surfaces
 Sanding steel surfaces
 Removing rust from steel surfaces
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 10.
To install:
 Insert the battery pack.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
product before beginning operation.
To remove:

Depress the latches on each side of the battery pack.
For complete charging instructions, see the operator’s manu-
als for your battery pack and charger.
TURNING THE SANDER ON/OFF
See Figure 2, page 10.
To turn the sander ON:
 Insert the battery pack.
 Push and release the ON/OFF button.
To turn the sander OFF:
 Push and release the ON/OFF button.
NOTE: The tool is always in the OFF mode when a battery
pack is not installed.
SANDPAPER SELECTION
Selecting the correct size grit and type sandpaper is an
extremely important step in achieving a high quality sanded
finish. Aluminum oxide, silicon carbide, and other synthetic
abrasives are best for power sanding. Natural abrasives,
such as flint and garnet, are too soft for economical use in
power sanding.
Orbit Diameter
....................................................... 1/16 in.
No Load Speed ............................................. 14,000 /min.