Owner`s manual

8
. Insert the caster stem into the socket
of the caster foot as shown. (Front
casters only).
9. Push on the caster until the ball on
the caster stem is inserted all the way
into the socket. You will be able to
hear the ball snap into the socket and
the caster will swivel easily when
positioning is correct.
10. Install (4) #10 x 1-3/4” screws into
matching holes on both right and left
side of caddy, securing the caddies to
the bottom of the drum. Tighten
screws until just snug. Do not over
tighten the screws, as this may
deform the caddies.
Installing Handle
Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release
buttons indicates successful engagement
of handle.
Removing Handle
Press and hold release buttons as
shown. While firmly pushing in release
buttons, pull handle upwards to remove
(see illustration).
Socket
Caster Stem
Caster Ball
Caster (2)
#10 x 1-3/4"
Screw (4)
Drum/Caddy Assembly (cont.)
11
SP6729 RIDGID 10/30/09 1:04 PM Page 11