Owner`s manual

Wet/Dry Vac Assembly
1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Wall Mount
Hook
Grommet
Wall
Tote Snaps
Tote
Straps (4)
Handle
Extension
Wand
Storage
Locations
Drum
Latch
Drum
Latch
Drum
Flange
Latch
Drum
Powerhead
Assembly
Installing Tool Holder
1. Install tool holder as shown with
extension wand holders facing unit.
Insert Hose
Insert the push button end of the “Tug-A-
Long™” hose into the inlet of the Vac.
The hose should snap into place. To
remove the hose from the Vac, press the
release button in the hose assembly and
pull the hose out of the Vac inlet, as
shown.
On the RV26000, press the curved metal
extension wand into the coupling ring of
the hose end.
Join the two metal extension wands,
aligning the button and hole so they snap
together.
Attach the accessories, aligning the
button and hole so they snap together.
Release
Button
Press
and
Pull
Coupling
Ring
Accessory
Metal
Extension
Wand
(Curved)
Metal
Extension
Wand
(Straight)
Wet/Dry Vac &
Hose Assembly
2. As an alternative storage solution, the
tool holder may hang on a wall. Two
wall mounting hooks (not provided)
must be secured to the wall as shown
(sold separately).
Drum/Caddy Assembly (cont.)
12
SP6729 RIDGID 10/30/09 1:04 PM Page 12