Instructions / Assembly

5
1. Turn the dust drum upside down on the
floor.
2. Insert the caster feet into the bottom of
drum, as shown (4 places).
3. Push on the caster foot until the foot is
flush with bottom of the dust drum.
4. Insert the caster stem into the socket
of the caster foot, as shown
(4 places).
5. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will
swivel easily when positioning is
correct.
6. Turn the drum upright.
Caster/Caster Foot Assembly
Caster
Foot
Dust
Drum
Pin
Caster
Hole
Caster Ball
Caster Stem
To install a new filter you must first
determine which filter attachment system
is used on your vac.
The filter cage has a stud on the end with
either screw threads to receive a filter
nut, or the Qwik Lock™ ball end which
will allow the filter to snap into place
without a filter nut or other attachment
hardware.
The stud type will determine which of the
following sets of instructions should be
used.
IMPORT
ANT:
T
o avoid damage to the
blower wheel, always reinstall the filter
before using the vac for dry material
pick-up.
Filter Removal and Installation
WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
!
— OR —
Threaded
Stud
Qwik
Lock™
Stud
Lid
Lid
Filter
Filter
SP6727 Ridgid 0909 9/30/09 9:00 AM Page 5