Instructions / Assembly

7
Wet/Dry Vac Assembly
1. Line up front of powerhead assembly
with Vacuum port located on the front
of the drum, as shown.
NOTE: Powerhead assembly must be
aligned with drum for proper attachment.
2. Place powerhead assembly on top of
drum.
3. Be sure powerhead assembly
completely covers the top of the drum
so leakage does not occur.
4. Push down on top of handles to cause
flexible locking tabs to hook onto the
drum lip.
5. Make sure that the locking tabs are
snapped into place as shown, to
prevent the lid from coming off.
6. To remove the powerhead assembly,
reverse above directions.
Flexible Locking Tab
(located under latch)
Push
Down to
Latch
Pull
Out to
Unlatch
Flexible Locking
Tab Pulled Out
Flexible
Locking Tab
Drum
Power
Assembly
Insert Hose
Insert the larger end of the hose into the
vacuum port.
Place the utility nozzle securely on the
opposite end of the hose and the vac is
ready for use.
Release
Button
Power
Assembly
Vacuum Port
SP6727 Ridgid 0909 9/30/09 9:00 AM Page 7