Full Product Manual

15
Filter
NOTE: The filter is made of high quality
paper designed to stop very small
particles of dust. The filter can be used
for dry debris or small amounts of liquid.
Handle the filter carefully when removing
or installing. Creases in the filter pleats
may occur from installation but will not
affect the performance of the filter.
Filter Cleaning
Your filter should be cleaned often to
maintain peak Vac performance.
Be sure to dry the filter before storing or
picking up dry debris.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use
a filter with holes or tears in it. Even a
small hole may allow a lot of dust to
come out of the exhaust port of your Vac.
Replace it immediately.
Filter Removal
Refer to page 5 "Filter Removal and
Installation" Section of this manual.
IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall
the filter before using the Vac for dry
material pickup.
Maintenance (continued)
Cleaning A Dry Filter
1. Light cleaning of some dry debris can
be accomplished without removing the
filter from the Vac. Simply slap your
hand on top of the lid while the Vac is
turned off.
2. Clean the filter in an open area.
Cleaning SHOULD be done outdoors
and not in the living quarters.
3. Remove filter from Vac. Gently tap
filter against the inside wall of your
dust drum. The debris will loosen and
fall.
4. For thorough cleaning of dry filter with
fine dust (no debris), run water
through it as described under
"Cleaning A Wet Filter".
Cleaning A Wet Filter
Remove filter from Vac and run water over
it to remove the dirt. Take care that water
pressure does not damage the filter
material.
Installation
Refer to page 5 "Filter Removal and
Installation" Section of this manual.
Allow the filter to dry before reinstalling
and storing the Vac.
SP6779-4 Ridgid WD1680 ES 1/29/14 11:27 AM Page 15