Replacement Part List

9
Positioning Detachable Blower
(Power Head Assembly)
Release
Button
Press and Pull
1. To remove the detachable blower from
the lid assembly, press down on the
detachable blower latch under the
detachable blower handle and lift the
blower off the lid of the Vac.
Detachable
Blower Handle
Detachable
Blower
Latch
3. Lightly press down on the carry handle
of the detachable blower until you
hear the “snap” of the detachable
blower latch engaging the detachable
blower. The detachable blower is now
latched to the lid assembly.
4. Your new Wet/Dry Vac is ready for
use. With the Wet/Dry Vac completely
assembled and ready for use, insert
the push button end of the “Tug-a-
Long” hose into the inlet of the Vac.
The hose should snap into place. To
remove the hose from the Vac, press
the release button in the hose
assembly and pull the hose out of the
Vac inlet, as shown.
Detachable
Blower
Molded
Leads
2. To replace the detachable blower onto
the lid assembly, position detachable
blower above the indented area of the
lid assembly. Rotate the detachable
blower down until the travel of the unit
stops.
Detachable
Blower
Detachable
Blower Latch
SP6779-1 Ridgid WD1680 12/21/10 4:07 PM Page 9