User manual

INSTALLATION

CONNECTION

Connect the UPS to the mains power supply using the input supply cable. Connect the loads to the UPS sockets

with the IEC-IEC cables or with a similar cable with a maximum length of 10 metres.

Note: do not connect loads that draw more than 10A, to the 10A IEC sockets. These loads can only be

connected to the 16A IEC socket (where fitted).

CONNECTION TO THE NET/TEL PROTECTION DEVICE

A telephone/modem/network line can be connected to the modular RJ-45/RJ-11 connectors (located on the rear

of the UPS) to protect against surge voltages. A telephone extension cable is required for this type of

connection.

N.B.: This connection is optional. The Net/Tel protection is active even when the UPS is switched off or

disconnected from mains power.

Warning: The device that protects against overvoltages on the telephone line may not work if it is not installed

correctly. Ensure that the telephone line from the wall is inserted in the connector marked “IN” and that the cable

of the device to be protected (telephone, modem, network card, etc.) is inserted in the connector marked “OUT”.

N.B.: This protection device limits the effects of an overvoltage but does not guarantee absolute protection.

POWERSHARE

All the models of the Dialog Vision range are provided with an auxiliary output socket that can be configured via

UPSTools. The Powershare socket can be configured in five different ways (refer to the UPSTools manual) as

described below:

 ALWAYS: (standard configuration), the Powershare socket is always active; the load is powered, as if it

were connected to one of the other output sockets.

 BATTERY LOW: the Powershare socket is normally active, but after 10 seconds from the start of the

battery low signal, the Powershare socket is deactivated.

 BATTERY WORKING: the Powershare socket is active if the UPS is powered from the mains power

supply, if the UPS is working in battery mode; the Powershare socket is deactivated.

 BATTERY WORKING DELAYED: the Powerashare socket is always active, but after 1 minute of

operation in battery mode or after 10 seconds in a battery low condition, the Powershare socket is

deactivated.

 BUZZER: when the UPS is working in battery mode, the Powershare socket is activated and deactivated

in the same way as the buzzer.