User manual

SYSTEM DESCRIPTION

Table 1

Battery level

0%~20%

20%~40%

40%~60%

60%~80%

80%~100%

Table 2

Applied load level

0~5%

5~25%

25%~50%

50%~75%

75%~102%

flashing

>102%

In the event of an overload, the UPS will continue to power the load for a set period of time. The UPS will emit an

alarm to signal that it can no longer support the overload (a beep at regular one-second intervals). Once the load

has been reduced to within the 100% threshold, the UPS will return to normal operating mode.

Warning: If the overload is too high, the protection device will be activated and the UPS will shut down.

To restore normal operation following failure due to an overload (continuous beep and load not powered); reduce

the load so that it falls within the 100% threshold. Hold the OFF button down until the continuous beep stops and

then release it. Wait until the UPS has completely shut down and then switch on again using the ON key.