User Manual

LIMITED WARRANTY
Rightline Gear warrants that for one (1) year, from the
date of purchase that all PackRight and CampRight prod-
ucts will be free of material defect and Rightline Gear
will repair or replace any defective or damaged product
free of charge if it is returned in original condition by
the consumer to Rightline Gear or the place of purchase.
Claims of defective material and/or workmanship must
be made in a timely manner. Safe and maintenance-free
use of this product depends upon the consumer’s or user’s
proper installation of the product and good judgment in
its use. Rightline Gear is not responsible for the consumer’s
or user’s use or misuse of this product. Damage to Pur-
chaser’s vehicle or any other vehicle caused by Purchas-
er’s improper use of this product may cause serious injury
or death. The Purchaser acknowledges that Rightline
Gear has no control over the attachment of its products to
vehicles or the attachment of items to the Rightline Gear
products. Accordingly, Rightline Gear cannot assume re-
sponsibility for any damage to any property arising out
of the improper attachment or use of its products.
RIGHTLINE GEAR SPECIFICALLY DISCLAIMS ANY AND
ALL OTHER WARRANTIES WHETHER EXPRESS OR IM-
PLIED, INCLUDING BUT NOT LIMITED TO WARRANTY
OF MERCHANTABILITY AND WARRANTY OF FITNESS
FOR A PARTICULAR PURPOSE. RIGHTLINE GEAR FUR-
THER DISCLAIMS ANY WARRANTY OR OTHER PROMISE
THAT GIVES RISE TO ANY SORT OF CONSEQUENTIAL,
EXTRAORDINARY, PUNITIVE, EXEMPLARY, SUBSEQUENT,
OR NONECONOMIC DAMAGES OR ATTORNEY FEES.
THE CONSUMER OR USER’S SOLE REMEDY AGAINST
RIGHTLINE GEAR FOR ANY DEFECT IN THIS PRODUCT IS
LIMITED TO FULL RETURN OF THE PURCHASE PRICE.
RIGHTLINE GEAR SPECIFICALLY ENCOURAGES COM-
PLIANCE WITH ALL MOTOR VEHICLE LAWS, AND
EXPRESSLY DISCLAIMS ANY AND ALL LIABILITY FOR
FAILURE TO COMPLY WITH SAME.
Lower the 60/40 split-folding rear bench seat and the
Midgate®. Remove the rear window and the three piece
tonneau cargo cover (Fig 12). Set up is exactly the same
as the other truck tents with the following exceptions:
CAUTION: Metal magnets are located inside the front
of the rain y to hold it in place on the roof of the ve-
hicle. Be careful when placing the rainy on the roof
of your Avalanche.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC
This tent meets the ammability requirements of
CPAI-84. The fabric may burn if left in continu-
ous contact with any ame source. The applica-
tion of any foreign substance to the tent fabric may
render the ame resistant properties ineffective.
In Step 7, the (2) black straps on the front of the rainy
should be secured inside the vehicle to the front cleats (Fig
16). The vehicle’s doors shut over the straps.
If the Avalanche has a running board, attach the black
strap clips down and around the running board to the
truck’s body (Fig 15) or attach them to the truck’s wheel
well.
Visit: www.rightlinegear.com
Fig 13
Fig 14
Fig 15
In Step 2, place the stitched front edge of the tent (has
(2) tie down strings sewn inside) in the gap between the
plastic rear window frame and the metal roof (Fig 13). All
(3) black strap clips from the front of the tent will attach
in a row to the bottom of the Avalanche body (Fig 14).
The pressure along these straps from one side of the Ava-
lanche to the other side will hold the front edge in the gap.
Fig 12
Fig 16
Setting Up the Avalanche Truck Tent