Owners manual

2017+ CAN-AM

MAVERICK X3

DOME LIGHT MOUNT

INSTALLATION INSTRUCTIONS

*THIS MOUNT FITS THE FOLLOWING LIGHTS:

(1) A-Series

PRODUCT INCLUDES:

(1) Dome Light Mount Bracket #41636

* LIGHTS SOLD SEPARATELY

IMPORTANT

THANK YOU FOR PURCHASING RIGID PRODUCTS FOR YOUR VEHICLE.

Please read through all of these Instructions and tips before proceeding with the installation.

We do our best to provide a simple installation process for all applications however

a professional installation is always recommended.

Always disconnect any power sources connected to your vehicle

before servicing fuses or electrical systems.

STEP 1

Install the A-Series light onto the RIGID dome light bracket using the provided hardware.

STEP 2

Remove the factory rear view mirror bolt and then install the new RIGID bracket. Re-install the factory

bolt and tighten.

See Figures 2, 2.1

PAGE 1
INSTALLATION INSTRUCTIONS 2017+ CAN-AM® MAVERICK X3® DOME LIGHT MOUNT PRODUCT INCLUDES: (1) Dome Light Mount Bracket #41636 * LIGHTS SOLD SEPARATELY *THIS MOUNT FITS THE FOLLOWING LIGHTS: (1) A-Series® IMPORTANT THANK YOU FOR PURCHASING RIGID PRODUCTS FOR YOUR VEHICLE. Please read through all of these Instructions and tips before proceeding with the installation. We do our best to provide a simple installation process for all applications however a professional installation is always recommended.
PAGE 2
FIGURE 2 FIGURE 2.1 STEP 3 FIGURE 3 Once the mirror bolt is tight, aim light downward and you are finished with the installation. See Figure 3 Wiring: Wire your lights according to the instructions included with the light. Take care to avoid any heat sources and sharp or abrasive surfaces. Your installation is now complete. Welcome to the Rigid Nation! WARRANTY INFORMATION For warranty information, visit www.rigidindustries.com/about/warranty 779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337 www.