User manual

RIGOL Chapter 2 Front Panel Operations
2-16 DP800A User’s Guide
2. Read
Press Read to enter the store and recall interface, the file type is fixed at “*.rtf”
and please read the desired file according to the introduction in “
Store and
Recall”. Users can edit the timer file read.
To Enable the Timer
After setting the timer parameters, press Timer  Timer to enable the timing
output. The timing output interface is as shown in the figure below.
Figure 2-2 Timing Output Interface
Tip
 Enabling the timer will change the output value of the channel; make sure
that the change in the output value will not affect the device connected to
the power supply before enabling the timer.
 The timing output is valid only when both the timer and the channel output
are turned on.
 When the timer is enabled, the timer parameters cannot be modified and
Delayer is grayed out and disabled.