User manual

Chapter 2 Front Panel Operations RIGOL
DP800A User’s Guide 2-17
To Set the Delayer Parameters
Press Timer  Delay Set to enter the delayer parameter setting interface as shown
in the figure below. The channel currently selected is displayed in the status bar.
Press the channel selection keys to switch channel. This interface provides delayer
parameter preview. Users can view the values on the current page of the delayer
parameter list. High level indicates turning on the output and low level indicates
turning off the output.
Figure 2-3 Delayer Parameter Setting Interface
Number of Groups
The number of groups refers to the number of times that the instrument turns on or
off the output according to the preset state. Press Groups and use the knob or
direction keyboard to input the value. The range is from 1 to 2048.
Number of Cycles
The number of cycles refers to the number of times that the instrument performs
delay output according to the preset state. Press Cycles to set the number of cycles
to “Infinite” or use the knob or numeric keyboard to input the value and the range is
from 1 to 99999.
Delayer Parameter Preview Channel Currently Selected Delayer Parameter List