User manual

RIGOL Chapter 2 Front Panel Operations
2-20 DP800A User’s Guide
Save and Read
You can save the delayer parameters edited manually or generated automatically in
internal or external memory and recall them when required.
1. Save
After finishing editing the delayer parameters, press Save to enter the store and
recall interface, the file type is fixed at “*.rdf” and please save the file according
to the introduction in “
Store and Recall”.
2. Read
Press Read to enter the store and recall interface, the file type is fixed at “*.rdf”
and please read the desired file according to the introduction in “
Store and
Recall”. Users can edit the delay file read.
To Enable the Delayer
After setting the delayer parameters, press Timer  Delayer to enable the delay
output. The delay output interface is as shown in the figure below.
Figure 2-4 Delay Output Interface
Tip
 Enabling the delayer will change the output state of the channel. Please
make sure that the change of the output state will not affect the devices
connected to the power supply before enabling the delayer.
 When the delayer is enabled, the delayer parameters cannot be modified
and Timer is grayed out and disabled.