User manual

RIGOL Chapter 2 Front Panel Operations
2-32 DP800A User’s Guide
Display Mode
Press Display  Disp Mode to set the display mode to “Normal”, “Waveform” or
“Dial”.
 Normal: display the voltage, current and power values of all the channels in
number form.
 Waveform: display the voltage, current and power values of the channel
currently selected in waveform and digital forms.
 Dial: display the voltage, current and power values of the channel currently
selected in dial and digital forms.
Tip
When the current display mode is “Normal” or “Waveform”, press at the
front panel to switch between the current display mode and dial display mode.
User-defined Start-up Interface
DP800A allows users to define the start-up interface. You can store the content to be
displayed in an USB storage device in BMP format. Insert the USB storage device into
the USB HOST interface at the rear panel of the power supply, select the desired BMP
file and set the coordinate of the file in the interface.
Press Display  CustomGUI to enter the interface as shown in the figure below.
Figure 2-8 User-defined Start-up Interface
Area 1
Area 2