User manual

RIGOL Chapter 3 Remote Control

3-2 DP800A User’s Guide

Remote Control via USB

1. Connect the device

Connect the USB DEVICE interface at the rear panel of DP831A with your PC

using a USB cable.

2. Install the USB driver

This power supply is a USB-TMC device. Assuming that your PC has already been

installed with Ultra Sigma, after you connect the power supply to the PC and

turn both on for the first time (the power supply is automatically configured to

USB interface), the New Hardware Wizard as shown in the figure below is

displayed on the PC. Please install the “USB Test and Measurement Device”

driver following the directions in the wizard. The steps are as follows.