Product Manual

9
Assembly
6. The feed handle (A-Fig.06) is secured to the
feed shaft with the supplied Allen bolt
(B-Fig.06).
Fig.06
A
B
7. Depth Stop: The depth stop and scale are
found on the left side of the switch box. To
adjust, lower the drill chuck until pointer shows
desired depth on the scale. Loosen the
lower nut on the threaded shaft (A-Fig.07) until
it bottoms out on the head casting (B-Fig.07).
Tighten upper nut against the lower nut to
retain the adjustment.
Fig.07
A
B
8. Table Tilt: The drill press table will tilt 0-45
degrees left and right. To tilt, loosen the nut
located under the table (A-Fig.08). Align the
“zero” mark on the table (B-Fig.08) to the
desired degree marking on the scale. Tighten
the nut under the table to retain the
adjustment.
Fig.08
Adjustments
A
B