SDS

Shenzhen HuanYuYuan Technology Co., Ltd.
Page
11
of
14
Page 11 of 14
Protective gloves
Material of gloves:
The selection of the suitable gloves does not only depend on the material, but also on further marks
of quality and varies from manufacturer to manufacturer. As the product is a preparation of several
substances, the resistance of the glove material can not be calculated in advance and has therefore
to be checked prior to the application.
Penetration time of glove material:
The exact break trough time has to be found out by the manufacturer of the protective gloves and
has to be observed.
Respiratory Protection No protective equipment is needed under normal use conditions. If
exposure limits are exceeded or irritation is experienced, ventilation and evacuation may be
required.
Hygiene Measures Handle in accordance with good industrial hygiene and safety practice.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical
State
Form: Prismatic
Color: Blue
Odour: Odourless
Odor Threshold: No information available
Change in condition:
pH, with indication of the concentration
Not determined.
Melting point/freezing point
Not determined.
Initial boiling point and Boiling range:
Not determined.
Flash Point
Not determined.
Evaporation rate
Not determined.
Flammability (solid, gas)
Not determined.
Upper/lower flammability or explosive limits
Not determined.
Vapor Pressure:
Not determined.
Vapor Density:
Not determined.
relative density:
Not determined.
Solubility in Water:
Not determined.
Solubility in other solvents
Not determined.
n-octanol/water partition coefficient
Not determined.