IP Router Owner Manual

5
Using PeripheralVision
®
to Configure the IP Router
Full Installation and operational procedures for
PeripheralVision
®
are dealt with in the separate
manual accompanying the Installation CD, refer
to this if any problems are encountered in the
procedure detailed below.
Install PeripheralVision
®
onto a PC on Network
One. Using the Locate NPMP
TM
discovery tool in
PeripheralVision
®
, enter the default set IP
address (11.22.33.44). The IP router will appear
on the network map, it will be an icon similar to
the example on the left.
Left click twice on the icon to open up the property
Pages of the device. Using the arrows in the top
right corner, scroll the pages and click on the first
IP Router page. This is shown below.
The following information needs to be entered
onto this page (this will be supplied by your
network administrator).
IP Address Enter here the router’s IP address for Network 1.
TCP/IP Subnet Mask Enter here the subnet mask for Network 1.
11.22.33.44