Infinity 24e Continuous Flow Water Heater User's Manual

23
Using High Temperature Display Controllers.
You will need to program the Master controller if you want to display and use
temperatures over 50
0
C. Programming only needs to be done on Master universal
controllers; other universal controllers will not allow this, and Deluxe Kitchen Controllers
are supplied already programmed to allow high temperatures. Temperatures in
bathrooms should never exceed 50
0
C.
STEP 1: On the Master controller only press and hold the Transfer and On/Off
buttons simultaneously (see fig 2.) until a “beep” is heard (approx. 5 seconds)
STEP 2: When the Primary controller is switched on it should be possible to select
temperatures higher than 50ºC. If not repeat STEP 1.
Note:
If the master controller is replaced, repeat STEP 1 above for the new controller.
TEMPERATURE CONTROLS - OPERATING