Service manual

Maintenance

DRAWING B

Manifold & Burner Box Removal

1. To remove Manifold (A) undo all 9 screws (1) then pull forward, disconnect solenoid ( see

drawing G connection 2A) Inspect injectors if required remove front plate off manifold and

clean injectors outwards

2. Remove Combustion Chamber Plate (B) by undoing all screws (2) and clean ignition and Ioni-

sation electrodes, to remove these undo screws (3) PRIOR TO CARRYING THIS OUT EN-

SURE YOU HAVE THE GASKET

3. To remove burner box undo 2 screws (4) on plate C this will now allow full burner box to be

withdrawn and the burners to be cleaned ( turn upside down and shake and blow through with

air brush)

4. If any burner wings (D) are damaged remove bracket (E) by undoing screw (5) and pull dam-

aged wing out and replace

5. To Rebuild reverse above ENSURING `O`RINGS ARE INTACT AND IN PLACE ON GAS

VALVE