User Guide

Operating instructions Rinnai E-Series

Replenishing the central heating system

The central heating installation needs to be lled with potable (drinking)

water. For topping up the installation you use the lling loop according to the

following procedure:

Contact your licensed professional installer if

your installation is not provided with a lling

loop.

1 Switch all functions off (heating, DHW and pump);

2 Briey push the 'STEP'-button: P x.x = water pressure in PSI;

3 Slowly open the lling loop (Indication on display increases);

4 Fill up slowly to between 16 and 18 PSI;

5 STOP appears on the display;

6 Close the lling loop;

7 De-aerate the complete installation , start at the lowest point;

8 Check the water pressure and if necessary top it up;

9 Close the lling loop;

10 Activate functions required (heating , DHW and/or pump );

11 If A xx appears on the display, wait for 17 minutes;

12 Check the waterpressure and if necessary top it up to 16 to 18 PSI

13 Close the lling loop;

14 Press the ‘STEP’-button;

15 Be sure that the lling loop is closed.

After the automatic de-aeration programm (A xx) is nished the boiler will

return to the Good reading or Technical reading.

NOTICE