Installation manual

Rinnai New Zealand Ltd. Continuous Flow Water Heater Installation Manual:

03-11

Controllers - Bathroom Deluxe installation

1. Determine the most suitable position for the controller.

2. Mark and drill three holes, locating the cable access hole as shown (Fig.1).

3. When running a cable through the access hole ensure the connector end of the cable is

located nearest to the controller (Fig.2).

4. Afx the double sided self-adhesive seal to the back of the controller (Fig.3).

5. Carefully remove the face plate from the controller. Do this by placing your thumbs on the

front digital display while hooking your ngers behind the top plate and gently push down

as shown (Fig.4). Do not use a screwdriver as this may damage the controller.

6. Connect the cable to the bathroom controller. Feed excess cable lengths into the wall cavity

to avoid pinching of cables between the wall and the controller.

7. Fix bathroom controller to the wall using appropriate xings. Avoid the use of impact drills

and over-tightening of xings as this may damage the controller.

8. Remove the protective plastic from the controller face and replace the face plate.

181

195

Outline of Water Controller

Securing

Screw

Ø20 Cable Access

Connector

Controller Cable

Backing Seal

Remove

to expose

self-adhesive

Fig.1

Fig.4

Fig.2

Fig.3