Installation manual

Rinnai New Zealand Ltd. Continuous Flow Water Heater Installation Manual:
03-11
20
Controllers - communication cables
Connecting three to four controllers
1. Repeat steps 1-3 on previous page.
2. To connect three to four controllers, separate all the cables to be tted into pairs. Cut off
the existing spade connectors from each pair and re-terminate each pair into a new spade
connector (F) (available from your local electrical supplier) so there are only two sets of
spade connectors. Four spade connectors in total to be terminated.
3. Repeat steps 4 and 5 on previous page.
Three
Cables
Four
Cables
F F F
Spade connectors are available from your local electrical supplier.