RiteTemp Evaporative Cooler Information Brochure (internal) RiteTemp Cool-Air 5051 Introduction to use of Evaporative Cooler RiteTemp Benefits of Unit Basic Operation and Maintenance Frequently Asked Questions Atlanta, Ga Phone: 888-515-2585 E-mail: support@ritetemp-thermostats.
RiteTemp Internal Document RiteTemp Notes Page 2 Page 15
RiteTemp Internal Document RiteTemp Frequently asked Questions continued Table of Contents For best cooling what speed should I run the fan? Bases of Operation 4 Basic Components 4 Unit Benefits 5 Filling the Cooler 6 Yes, you can do this by turning just the fan switch and leaving the pump switch in off.
RiteTemp Internal Document RiteTemp Evaporative Cooler - Model 5051 Frequently asked Questions Bases of Operation How long will the evaporative cooler cool on a water fill? The cool-air fan is used in hot dry climates to cool and humidify the air. The air coming out of the 5051 is normally 3-5 degrees cooler then the ambient room temperature. The unit works by pumping water from the main tank to the filter which looks similar to a cardboard honeycomb.
RiteTemp Internal Document RiteTemp Hints for Better Cooling ♦ ♦ ♦ Evaporative Cooler Start cooler fan while the room is still cool. You may leave it running all day and still save money due to the low power consumption. You will find that this system works best and keeps the room cool. Can be used as a supplement to an air conditioner for rooms that do not get enough cool air flow. Place the cooler fan near the entrance doorway.
RiteTemp Internal Document RiteTemp Filling the Cooler End of Season Maintenance and Storage continued Removing Side Tanks Make sure unit is unplugged from wall. Remove the side water tanks by lifting up and then away from the cooler. Take tanks and faucet attachment hose to sink or other water source. Stand tanks upside down on stable surface. Getting Cooler Ready for Storage continued Next put base unit on its side wheels down and allow water to drain out.
RiteTemp Internal Document RiteTemp End of Season Maintenance and Storage Replacing Evaporative Cooler Filter Motor This document outlines the procedure and precautions involved in the replacement of the filter media for the 5051 Evaporative cooler. Requires no oil, as it is permanently lubricated. The motor is equipped with a thermal 130 degrees C cut off fuse for safety. Materials needed: Medium blade Philips or flat blade screw driver A sturdy flat work area about 3 X 3 foot.
RiteTemp Internal Document RiteTemp Replacing Evaporative Cooler Filter continued Replacing Evaporative Cooler Filter continued Make sure the water outlets are away from you and the tabs that the screws were in are towards you. Starting on your right closest to you with your thumb gently push the plastic case out and with your left hand pop the metal retainer out. Repeat for the remaining two positions on the right side.