Quick Start Manual

R A

Motor Valve

PG 22

W RH [A?] 3 Zoned Hot Water - Motor Valve

Step 1 - based on your valve type

Motor driven Valve- Connect the R (or RH) wire to the RH

terminal on the 6030. Connect the W wire to the W terminal

on the 6030. Connect the remaining wire to the A terminal.

Solenoid valve -Connect the R (or RH) wire to the RH

terminal on the 6030. Connect the W wire to the A terminal

on the 6030. Connect the remaining wire to the W terminal.

STEP 2 - Set Config jumpers per this diagram.

Your system is now connected to the 6030.

  Please Go T o Page 9

WIRES

STEP 1 - Connect the W wire to the W terminal and W2 to

W2 on the 6030. This connects 2 stages of heat.

STEP 2 - Connect the Y wire to the Y terminal and Y2 wire

to Y2 on the 6030. This connects 2 stages of cool.

STEP 3 - Connect the RH or R wire to the RH terminal on

the thermostat. This connects the Heater/Cooler Power.

STEP 4 - Connect the G wire to the G terminal on the

Thermostat. This connects to the Fan.

STEP 5 - Set Config jumpers per this diagram. If you

have Electric heat set 4, if you have Gas or Oil set 5.

Your HVAC system is now connected

to the 6030.

Please Go To Page 9

W2 W Y Y2 RH G

PG 21

2 Stage Heat and Cool

6030

Terminals

6030

Terminals

HVAC SYSTEM

OPTIONAL

POWER

WIRES

C B O

Y Y2 RH RC G A

C B O

Y Y2 RH RC G A

SET JUMPERS

1 2 4 5