Quick Start Manual

This thermostat can be used with all millivolt and 24VAC heating and cooling systems. It
cannot be used with line voltage systems. This thermostat is digital and your desired heat or
cool temperatures can be easily be set on the large touch screen with the UP/DOWN arrows.
A minimum 4 minute off time protects heating and cooling systems from damage. 
This thermostat uses a new technique called sequential staging for more comfort with
faster reaction to requested temperature changes.
When using a heat pump with Auxiliary heat, if the
heat pump cannot keep up and/or is defective, touch
the MENU button, then touch PUMP; the PUMP OFF
icon will come on.. The aux heat will then be your only
source of heat. When the heat pump is again
operational, be sure to turn the heat pump back on by
touching MENU and then PUMP (off icon goes out) as
the aux heat is more expensive than pump heat.
6030 Features
Wire Reference
Your Wires Ritetemp Terminal
R or V or VR RH and RC Single power for HEA T and COOL
RH or 4    RH Power for HEA T (RH not connected to RC)
RC   RC Power for COOL (RH not connected to RC)
W   W Heat control
W2   W2 2nd stage HEA T or heat pump auxiliary heat
?    A 3rd wire for zoned hot water heat (see zoned)
Y   Y COOL control
Y2   Y2 2nd stage COOL control
G or F  G F AN control
C or X  C Common 24V AC power (to power thermostat)
E   Emergency heat (do not connect, tape of f)
L   System monitor (do not connect, tape of f)
T   Outdoor sensor (do not connect, tape of f)
B or   B Heat pump changeover (cool to heat, powered in heat)
O   O Heat pump changeover (heat to cool, powered in cool)
B and O  SEE NOTE 
PG 23
PG 24
B and O
NOTE: If
there are both
B and O wires
(Trane pump
products)
DO NOT
CONNECT B
to B terminal,
connect B to C
terminal
MENU
PROG
HEAT
COOL
OFF
FAN
AUTO
ON