Instructions / Assembly

MODEL NO.: QCF-DB52061

Page

8. Fan Assembly with Down Rod

- Choose the 4” or 21” Down Rod -

Remove Pin and Clip from down rod (if you have

not already done so). Slide the Down rod through

the canopy, and the Down rod cover as shown.

Thread the electrical wires through down rod and

pull extra wire slack from the upper end of the

down rod.

Tip: Apply small piece of electrical tape to the

ends of the electrical wires to keep them

together when threading them through the

down rod.

Loosen the Yoke set screw. Place the Down rod

into the Motor housing yoke and re-insert pin

and clip that were previously removed. Tighten

Yoke the set screw securely.

With the Hanging bracket secured to the outlet

box and able to support the fan, you are now

ready to hang your fan. Grab the fan firmly with

two hands. Slide down the rod ball through the opening

in the hanging bracket and let hanging ball rest on the

hanging bracket. Turn the hanging ball slot until it

lines up with the hanging bracket tab.

9. Wiring with Remote Receiver

IMPORTANT: you must set the ceiling fan manual pull chain switch

to HIGH speed and light kit to ON position to ensure proper

operation of the remote control.

WARNING: Failure to disconnect power supply prior to the installation may result in serious injury and fire

hazard.

CODE SWITCH – see next page diagram

1. Codes are set by pushing Dip switches up or down. It is imperative that the code used for both transmitter and

receiver is exactly the same, otherwise the remote controller will not work. Please note the code switch will enable

you to operate a second remote controller independently. For example, if you have two ceiling fans with 2 remote

control units, set 2 different codes for each set of transmitter/receivers. This means you can operate each ceiling

fan independently.

2. Your remote control is ready for use after the battery installation (9Volts battery included).

CAUTION: The battery will weaken with age and should be replaced before leaking takes place as this will

damage the transmitter. Dispose of used battery properly, keep the battery out of reach of children. To reduce the

risk of fire or injury, do not use this product in conjunction with any variable (rheostat) wall control.