Instructions / Assembly

MODEL NO.: 20063

Tiered Shade Installation (if applicable)

1. Remove the three (3) screws from Shade A and set

aside

2. Thread the pull chains through the designated holes in

Shade B

3. Align the three (3) holes from Shade B with the holes in

Shade A and insert the three (3) removed screws

Changing Bulbs (Flush Mount)

Need to change your motor housing bulbs? No worries! Follow

the steps below to guide you through the bulb changing

process, all while keeping your ceiling fan mounted

1. Locate the four (4) hex bolts on the bottom of the motor

housing (circled below), and remove using either a

wrench or socket wrench (5/16 or 8mm)

2. From the top of the motor housing, remove the four (4)

shade holding bolts

3. Gently life the shade to dislodge it from the motor

housing case, and slide to one side. This will allow

access to the bulbs

4. Remove and replace existing bubs (E12, Type 8-1, 1W)

5. Carefully center the shade back onto the bottom motor

housing case, and ensure the four (4) bolts on the top

and bottom motor housing are aligned

6. From the top of the motor housing, insert each bolt and

re-attach the four (4) hex bolts