Instructions / Assembly

MODEL NO.: 20063

6. Bulb Installation

1. Locate the four (4) access plates on the motor housing

2. On each access plate, remove the outer two (2) screws

using a phillips screwdriver and set aside

3. Install the provided bulbs

4. Reattach the access plates(s) with the removed screws,

ensuring that each screw is securely fastened

CAUTION - Refer to the Maximum Wattage

Caution Label located near the lamp holder for

recommended maximum wattage-do not

exceed recommended wattage.

WARNING - Do not attempt to replace the bulbs

while the line breaker is in ON position.

BULB INFO: E12, Type T8-1, 1W x 4 (Included)

Alternative bulbs usage: CFL or LED Bulbs may be used. Ensure the Max. Wattage indicated on the socket labels

is not exceeded, and verify the bulbs do not get in contact with any metal part of the fan components (shade or

motor housing)

7. Flush Mount Assembly

NOTE: If assembling with down rod, proceed to Step 8

1. Remove round rubber ring from canopy

2. Thread the electrical wires through the canopy

3. Remove every other screw on the motor housing (3

screws total)

WARNING – Ensure you only remove every

other screw, others must remain firmly tightened.

4. Attach the canopy to the motor housing securely with the

three (3) removed screws. Tighten firmly.

5. Continue to Step 8 for wiring