Instructions / Assembly

MODEL NO.: 20063

to the ground wire located on the down rod end.

The splices, after being carefully made, should be

turned

upward and pushed carefully up into the outlet box.

Note: Wrap each wire nut separately with electrical

tape as an

extra safety measure.

Important:

Make sure all electrical connections comply with Local

Codes or Ordinances and the National Electrical Code.

If you are unfamiliar with electrical wiring, or if the

house/building wires are different colors than those

referred to

in the instructions, please use a qualified

electrician.

10. Canopy Assembly

1. Loosen the four (4) screws/washers on the side of the

hanging bracket

2. Lift canopy to the hanging bracket, and secure the

canopy with the four (4) screws/washers. Securely tighten

screws

11. Blade Assembly

1. Locate fifteen (15) screws/washers in the hardware

pack

2. Hold blade arm up to blade and align the three (3)

holes

3. Insert three (3) screws/washers with fingers, and

tighten with a phillips screwdriver

4. Repeat Step 3 for the remaining blades

Attaching Blades to Motor Housing

5. Remove blade arm screws and lock washers from the

motor housing and set aside