Instructions / Assembly

MODEL

CF‐DB

52061

PAGE

CAUTION: Be sure outlet box is grounded properly and that a

ground wire (green or bare) is present.

Partially loosen screws in slotted holes of canopy. Remove

the other 2 screws (along with the star washers) -save for

later use. Twist canopy to remove hanging bracket.

Install hanging bracket to outlet box using original screws,

spring washers and flat washers provided with new or

original outlet box. If installing on a vaulted ceiling, face

opening of Hanging Bracket towards high point of ceiling.

Arrange electrical wiring around the back of the hanging

bracket and away from the hanging bracket opening.

CAUTION: It is very important that you use the proper

hardware when installing the hanging bracket as this will support

the fan.

ELECTRICAL OUTLET BOX

WARNING: It is recommended to contact a qualified electrician to replace the outlet box if not suitable for ceiling fans

1. If there is an existing outlet box, ensure it is clearly marked “Suitable For Fan Support”.

If not, it must be replaced with an approved one.

2. Secure the outlet box (or make sure the existing box is secured) directly to the

building structure. Use appropriate fasteners and building materials. Wood joist

and outlet box must be able to support a minimum of 50 pounds.

3. Figure 1, 2 and 3 are examples of different ways to mount the outlet box in

different situations.

4. To hang the fan in locations where no ceiling joists is available. A hanger support

bar may be required (Fig. 4)