Manualshelf

Instructions / Assembly

ManualsBrandsRiver of Goods ManualsCeiling FansHalston 52 in. Blue Tiffany Stained Glass LED Ceiling Fan With Light
12345678910
MODEL
N
O.
:Q
CF‐DB
52061
PAGE
7
8. Fan Assembly with Down Rod
- Choose the 4” or 21” Down Rod -
Remove Pin and Clip from down rod (if you have not already done so).
Slide the Down rod through the canopy, and the Down rod cover as
shown.
Thread the electrical wires through down rod and pull extra wire slack
from the upper end of the down rod.
Tip: Apply small piece of electrical tape to the ends of the electrical
wires to keep them together when threading them through the
down rod.
Loosen the Yoke set screw. Place the Down rod into the Motor housing
yoke and re-insert pin and clip that were previously removed. Tighten
Yoke the set screw securely.
With the Hanging bracket secured to the outlet box and able to support
the fan, you are now ready to hang your fan. Grab the fan firmly with
two hands. Slide down the rod ball through the opening in the hanging
bracket and let hanging ball rest on the hanging bracket. Turn the hanging
ball slot until it lines up with the hanging bracket tab.
9. Wiring with Remote Receiver
IMPORTANT: you must set the ceiling fan manual pull chain switch to
HIGH speed and light kit to ON position to ensure proper operation of the
remote control.
WARNING: Failure to disconnect power supply prior to the installation may result in serious injury and fire
hazard.
CODE SWITCH – see next page diagram
1. Codes are set by pushing Dip switches up or down. It is imperative that the code used for both transmitter and
receiver is exactly the same, otherwise the remote controller will not work. Please note the code switch will enable
you to operate a second remote controller independently. For example, if you have two ceiling fans with 2 remote
control units, set 2 different codes for each set of transmitter/receivers. This means you can operate each ceiling
fan independently.
2. Your remote control is ready for use after the battery installation (AAA batteries included).
CAUTION: The battery will weaken with age and should be replaced before leaking takes place as this will
damage the transmitter. Dispose of used batteries properly, keep the batteries out of reach of children. To reduce
the risk of fire or injury, do not use this product in conjunction with any variable (rheostat) wall control.