Product Manual

ManualsBrandsRiverside Pumps ManualsGas173 GPM (2") Trash Pump w/ Briggs & Stratton Vanguard™ Engine

SELF-PRIMING TRASH PUMP

MODEL / UT NUMBER / DESCRIPTION:

TP2B UTL1540W 2-INCH TRASH PUMP, BRIGGS & STRATTON ENGINE

TP2BC UTL1676Y 2-INCH TRASH PUMP, BRIGGS & STRATTON ENGINE, COMPACT ROLL CAGE

TP2H UTL1601Z 2-INCH TRASH PUMP, HONDA GX160 ENGINE

TP2HC UTL1677Z 2-INCH TRASH PUMP, HONDA GX160 ENGINE, COMPACT ROLL CAGE

TP2Y UTL1631Z 2-INCH TRASH PUMP, YANMAR DIESEL ENGINE

INSTRUCTIONS & PARTS LIST

SYMBOL DEFINITION

• Always keep the machine and associated equipment clean, properly

serviced and maintained according to the instructions in this manual.

• Observe all safety regulations for the safe handling and storage of

fuel. Handle fuel in approved vented fuel cans. Do not store fuel

supplies in a garage, shed or other areas attached to living quarters.

Do not refill the fuel tank in an area attached to living quarters. Do not

refill the engine while it is running or hot. Carefully clean up any

spilled fuel before starting the engine.

• Do not smoke or bring flame near gasoline.

• Do not operate the pump at shut-off pressure for more than 2 minutes.

• Do not operate this pump if any safety equipment or guard has been

removed.

• Never operate the machine in any explosive atmosphere, near

combustible materials, or where there is not enough ventilation to

carry off the exhaust fumes. DO NOT operate pump indoors or in crawl

spaces.

• Always be sure the machine is on secure footing and cannot shift to

where it might injure someone. Remember that the suction hose on

the pump tends to pull the pump towards the liquid source during

pumping.

• Keep the immediate area free of bystanders.

• When pulling the starter, be sure that nothing is in a position to be hit

by the operator’s hand or arm, or the starting rope.

• Do not touch the hot cylinder and muffler area.

• Shut off the engine and disconnect the spark plug wire before working

on any part of the machine.

• Long or continuous exposure to high noise levels, such as in the

operation of a gasoline engine, may cause permanent hearing

impairment or other possible effects. Hearing protection devices are

available from your dealer, or can be ordered through him.

• Use only genuine product manufacturer’s replacement parts. Failure

to do so may cause poor fit and possible injury.

•

BEWARE OF USING THIS EQUIPMENT IN CONFINED SPACES.BEWARE OF USING THIS EQUIPMENT IN CONFINED SPACES.

BEWARE OF USING THIS EQUIPMENT IN CONFINED SPACES.

Confined spaces, without sufficient fresh air ventilation, can contain

dangerous gases. Running gasoline engines in such environments

can lead to deadly explosions and/or asphyxiation.

Do not pump flammable materials. Fire could occur.

Do not pump hazardous material.

Read your product literature before use.

Do not smoke or bring flame near gasoline.

SAFETY PRECAUTIONS

• This pump is designed for pumping only water. Under no circumstances

should it be used for pumping hazardous materials including

flammable materials such as gasoline.

• Before start-up, study all of the instructions in this manual. Be sure

you thoroughly understand how to operate the pump. Proper

preparation, operation and simple maintenance will improve operator

safety, pump performance and long unit life.

• Be sure that each person who operates the machine is properly

instructed as to its safe operation.

Disconnect spark plug before performing

maintenance, adjustment, lubrication, and

storage.

Part No. L19956 Rev. H 2009/11/17

Summary of content (16 pages)

PAGE 1
SELF-PRIMING TRASH PUMP TP2B TP2BC TP2H TP2HC TP2Y UTL1540W UTL1676Y UTL1601Z UTL1677Z UTL1631Z MODEL / UT NUMBER / DESCRIPTION: 2-INCH TRASH PUMP, BRIGGS & STRATTON ENGINE 2-INCH TRASH PUMP, BRIGGS & STRATTON ENGINE, COMPACT ROLL CAGE 2-INCH TRASH PUMP, HONDA GX160 ENGINE 2-INCH TRASH PUMP, HONDA GX160 ENGINE, COMPACT ROLL CAGE 2-INCH TRASH PUMP, YANMAR DIESEL ENGINE INSTRUCTIONS & PARTS LIST SYMBOL DEFINITION Do not pump flammable materials. Fire could occur. Do not pump hazardous material.
PAGE 2
UNCRATING THE PUMP OPERATING INSTRUCTIONS Look carefully for shipping damage. lf damage of any sort is detected, notify your dealer or the shipper. Remove all shipping blocks and clamps. If the unit is engine-driven, it is very important that it be free to float on it's springs. 1. Use a strainer on the end of the suction line. 2. Make sure that all hose and pipe connections are air tight. An air leak in the suction line may prevent priming and will reduce the lift capacity of the pump. 3.
PAGE 3
IMPELLER & SEAL SERVICING LIMITED WARRANTY A loss of pump performance may indicate wear of the impeller or seal. To disassemble the unit for inspection and/or cleaning, loosen the four disconnect handles, swing them aside, and remove the end housing. Examine all gaskets for wear or damage that would cause leaks. Replace any faulty gaskets. If the impeller is severly worn it must be replaced. 1. Turn the impeller nut to the left with a 3/4-inch wrench. Remove the impeller.
PAGE 4
POMPE DE CHANTIER TP2B TP2BC TP2H TP2HC TP2Y UTL1540W UTL1676Y UTL1601Z UTL1677Z UTL1631Z MODÈLE / UT NOMBRE / DESCRIPTION: 2" POMPE DE CHANTIER, BRIGGS & STRATTON MOTEUR 2" POMPE DE CHANTIER, BRIGGS & STRATTON MOTEUR, COMPACTE CHÂSSIS 2" POMPE DE CHANTIER, HONDA GX160 MOTEUR 2" POMPE DE CHANTIER, HONDA GX160 MOTEUR, COMPACTE CHÂSSIS 2" POMPE DE CHANTIER, YANMAR DIESEL MOTEUR INSTRUCTIONS ET LISTE DE PIECES DE RECHANGE DÉFINITION DES SYMBOLES Ne pas pomper de produits inflammables.
PAGE 5
DÉBALLAGE DE LA POMPE DIRECTIVES DE FONCTIONNEMENT Vérifier soigneusement si l’appareil a été endommagé pendant le transport. Si c’est le cas, en aviser le concessionnaire ou le transporteur. Enlever toutes cales et pinces d’emballage. Si l’appareil est actionné par un moteur, il est très important que le mouvement du moteur sur ses ressorts ne soit pas entravé. 1. Il est préférable de mettre un filtre à la fin de la tuyauterie d’aspiration. 2.
PAGE 6
ENTRETIEN ET RÉPARATION DU ROTOR ET DU JOINT GARANTIE LIMITÉE Riverside Pump Manufacturing Inc. garantit à l’acquéreur original (vente au détail) que ce produit Riverside Pump Manufacturing ne présente pas de défauts de matière ou de main d’oeuvre, et s’engage à réparer ou à remplacer (à la discrétion de Riverside Pump Manufacturing's) n’importe quel produit défectueux gratuitement au cours de la période de temps Deux Ans de la date de l’achat.
PAGE 7
AUTOCEBADO BOMBA CENTRIFUGA TP2B TP2BC TP2H TP2HC TP2Y UTL1540W UTL1676Y UTL1601Z UTL1677Z UTL1631Z MODELO / UT NÚMERO / DESCRIPCIÓN: 2" BOMBA PARA DESPERDICIO, BRIGGS & STRATTON MOTOR 2" BOMBA PARA DESPERDICIO, BRIGGS & STRATTON MOTOR, CHASIS COMPACTO 2" BOMBA PARA DESPERDICIO, HONDA GX160 MOTOR 2" BOMBA PARA DESPERDICIO, HONDA GX160 MOTOR, CHASIS COMPACTO 2" BOMBA PARA DESPERDICIO, YANMAR DIESEL MOTOR INSTRUCCIONES Y LISTA DE PARTES DEFINICIONES DE LOS SIMBOLOS No use la bomba para materiales inflamab
PAGE 8
DESEMBALAJE DE LA BOMBA INSTRUCCIONES DE USO Busque cuidadosamente la existencia de daños en el envío. Si se detectan daños de cualquier índole, notifique a su distribuidor o al expedidor. Quite todos los protectores de envío y las pinzas. Si la unidad es conducida por un motor, es muy importante que tenga la libertad de flotar sobre sus resortes. 1. Es conveniente usar una malla de filtro en el extremo de la línea de aspiración. 2.
PAGE 9
SERVICIO DEL IMPULSOR Y DEL SELLO GARANTIA LIMITADA La pérdida de rendimiento de la bomba puede indicar que el impulsor o el sello están desgastados. Si se desea desmontar la unidad para efectuar tareas de inspección y/o limpieza, se deben aflojar las cuatro manetas de desconexión, desplazarlas a un lado y sacar el armazón del extremo y el armazón del impulsor. Examine todas las juntas para ver si existen desgastes o daños que puedan dar origen a fugas. Reemplace las juntas que tengan defectos.
PAGE 10
SELBSTANSAUGENDE SCHMUTZWASSERPUMPE TP2B TP2BC TP2H TP2HC TP2Y UTL1540W UTL1676Y UTL1601Z UTL1677Z UTL1631Z MODELL / UT NUMMER / BESCHREIBUNG: 2" SCHMUTZWASSERPUMP, BRIGGS & STRATTON MOTOR 2" SCHMUTZWASSERPUMP, BRIGGS & STRATTON MOTOR, KOMPAKTER RAHMEN 2" SCHMUTZWASSERPUMP, HONDA GX160 MOTOR 2" SCHMUTZWASSERPUMP, HONDA GX160 MOTOR, KOMPAKTER RAHMEN 2" SCHMUTZWASSERPUMP, YANMAR DIESEL MOTOR ANLEITUNG UND TEILELISTE ERKLÄRUNG DER SYMBOLE Keine brennbaren Materialien pumpen. Es kann zu Bränden kommen.
PAGE 11
AUSPACKEN DER PUMPE BETRIEBSANLEITUNG Achten Sie sorgfältig auf Versandschäden. Wenn Sie irgendeinen Schaden bemerken, benachrichtigen Sie Ihren Händler oder den Spediteur. Entfernen Sie alle Versandblöcke und Klammern. Wenn das Gerät einen Motorantrieb hat, ist es sehr wichtig, dass dieser frei auf den Federn schwebt. 1. Verwenden Sie ein Sieb am Ende der Saugleitung. 2. Stellen Sie sicher, dass alle Schlauch- und Rohranschlüsse luftdicht sind.
PAGE 12
WARTUNG DES PUMPENRADS UND DER DICHTUNG EINGESCHRÄNKTE GARANTIE Riverside Pump Manufacturing Inc. garantiert gegenüber dem ursprünglichen Käufer, dass dieses Produkt von Riverside Pump Manufacturing Inc. frei von Material- und Fertigungsfehlern ist, und erklärt sich damit einverstanden, nach eigenem Ermessen von Riverside Pump Manufacturing Inc., defekte Produkte innerhalb eines Zeitraums von zwei Jahren ab Kaufdatum kostenlos zu reparieren oder zu ersetzen.
PAGE 13
PAGE 14
PARTS LIST / LISTE DE PIECES DE RECHANGE / LISTA DE PARTES / TEILELISTE 15 21 22* 14 16 27* 26 27* 13 1 3 8 4 5 11 28* 18 9 31 30 23 24* 12 25* 17 2 6 10* 20 * Included in A 48376 B Overhaul Seal Kit REF. NS NS NS 1 2 3 4 5 6 8 9 10 11 12 13 14 15 16 17 19* PART NO. DESCRIPTION QTY. 15131 Engine, Vanguard 6½hp (TP2B) ........................ 1 00971 Engine, Honda GX160 5½hp (TP2H) ................. 1 15047 Engine, Yanmar Diesel 4.7hp (TP2Y) ................. 1 54741 Impeller Nut ...
PAGE 15
PARTS LIST / LISTE DE PIECES DE RECHANGE / LISTA DE PARTES / TEILELISTE ROLL CAGE: TP2B • TP2H • TP2Y 1* 5* TORQUE SPECS REF NO. Inch Pounds 5 205-225 7 205-225 8 130-145 3* Newton Meters 23.2-25.4 23.2-25.4 14.7-16.4 Notes: 17-18.8 Lbs.-Ft. 17-18.8 Lbs.-Ft. 7* * Included in A 15022 Roll Cage Kit (Kit includes additional items for S2 models) 6* 3* 2* 4* REF. PART NO. DESCRIPTION QTY. *1 A 08096 Roll Cage .............................................................. 1 *2 83002 Lock Washer, 5/16" .....
PAGE 16