Product Manual

3
Reassemble the pump and turn the engine over by hand. Listen for
scraping noises which indicate insufficient impeller-to-wear plate
clearance. Adjust, if necessary, by removing a shim.
IMPELLER & SEAL SERVICING
A loss of pump performance may indicate wear of the impeller or seal. To
disassemble the unit for inspection and/or cleaning, loosen the four
disconnect handles, swing them aside, and remove the end housing.
Examine all gaskets for wear or damage that would cause leaks. Replace
any faulty gaskets.
If the impeller is severly worn it must be replaced.
1. Turn the impeller nut to the left with a 3/4-inch wrench. Remove the
impeller.
Retain the shims below the impeller.
2. Remove the spring and seal body and the spacer from the shaft.
3. To replace a damaged seal seat, pry the assembly out of the impeller
housing with a small screwdriver and discard.
CLEAN THE RECESSCLEAN THE RECESS
CLEAN THE RECESSCLEAN THE RECESS
CLEAN THE RECESS
THOROUGHLYTHOROUGHLY
THOROUGHLYTHOROUGHLY
THOROUGHLY. When installing a new seal, lightly oil the impeller
housing recess and slide the assembly into position.
4. Push the new seal into the recess as far as it will go.
5. Slide the spring and seal body on the shaft.
6. Replace the spacer and the shims removed previously.
7. Screw the impeller onto the shaft.
8. Adjust the clearance by adding or removing shims below the impeller.
LIMITED WARRANTY
Riverside Pump Manufacturing Inc. warrants to the original retail purchaser that
this Riverside Pump Manufacturing
Product is free from defects in material and
workmanship and agrees to repair or replace, at the discretion of Riverside Pump
Manufacturing, Inc., any defective Product free of charge within the time period
of
Two YearsTwo Years
Two YearsTwo Years
Two Years from the date of purchase.
This warranty is not transferable and does not cover damage resulting from
defects other than in material or workmanship, or damage caused by
unreasonable use, including the failure to provide reasonable and necessary
maintenance. Also, the warranty obligations do not apply to conditions resulting
from misuse, alteration or accident. In addition, this warranty does not cover
replacement of non-defective parts (such as seals, wear plates and impellers)
that may wear and need to be replaced with reasonable use within the warranty
period or which may require replacement in connection with normal maintenance.
SAVE YOUR SALES SLIPSAVE YOUR SALES SLIP
SAVE YOUR SALES SLIPSAVE YOUR SALES SLIP
SAVE YOUR SALES SLIP
Proof of purchase in the form of your dated sales receipt, cash register slip, etc.
showing the serial number and the model of your Product will be required. You
must, at your own expense, arrange to deliver or ship the Product for warranty
repairs and arrange for pickup or return of the Product after repairs have been
made.
THIS WARRANTY DOES NOT APPLY TO ANY TRADE ACCESSORY OR ENGINETHIS WARRANTY DOES NOT APPLY TO ANY TRADE ACCESSORY OR ENGINE
THIS WARRANTY DOES NOT APPLY TO ANY TRADE ACCESSORY OR ENGINETHIS WARRANTY DOES NOT APPLY TO ANY TRADE ACCESSORY OR ENGINE
THIS WARRANTY DOES NOT APPLY TO ANY TRADE ACCESSORY OR ENGINE
WHICH IS SEPARATELY WARRANTED BY ANOTHER MANUFACTURER AND NOTWHICH IS SEPARATELY WARRANTED BY ANOTHER MANUFACTURER AND NOT
WHICH IS SEPARATELY WARRANTED BY ANOTHER MANUFACTURER AND NOTWHICH IS SEPARATELY WARRANTED BY ANOTHER MANUFACTURER AND NOT
WHICH IS SEPARATELY WARRANTED BY ANOTHER MANUFACTURER AND NOT
MANUFACTURED BY RIVERSIDE PUMP MANUFACTURING INC.MANUFACTURED BY RIVERSIDE PUMP MANUFACTURING INC.
MANUFACTURED BY RIVERSIDE PUMP MANUFACTURING INC.MANUFACTURED BY RIVERSIDE PUMP MANUFACTURING INC.
MANUFACTURED BY RIVERSIDE PUMP MANUFACTURING INC.
THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES.THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES.
THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES.THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES.
THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES.
ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE,ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE,
ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE,ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE,
ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE,
MERCHANTABILITY OR OTHERWISE, APPLICABLE TO THIS PRODUCT, SHALLMERCHANTABILITY OR OTHERWISE, APPLICABLE TO THIS PRODUCT, SHALL
MERCHANTABILITY OR OTHERWISE, APPLICABLE TO THIS PRODUCT, SHALLMERCHANTABILITY OR OTHERWISE, APPLICABLE TO THIS PRODUCT, SHALL
MERCHANTABILITY OR OTHERWISE, APPLICABLE TO THIS PRODUCT, SHALL
BE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.BE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.
BE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.BE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.
BE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.
RIVERSIDE PUMP MANUFACTURING INC. SHARIVERSIDE PUMP MANUFACTURING INC. SHA
RIVERSIDE PUMP MANUFACTURING INC. SHARIVERSIDE PUMP MANUFACTURING INC. SHA
RIVERSIDE PUMP MANUFACTURING INC. SHA
LL NOT BE LIABLE FOR ANYLL NOT BE LIABLE FOR ANY
LL NOT BE LIABLE FOR ANYLL NOT BE LIABLE FOR ANY
LL NOT BE LIABLE FOR ANY
SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIEDSOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIEDSOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. SOMEWARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. SOME
WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. SOMEWARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. SOME
WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. SOME
STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL ORSTATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL ORSTATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAYCONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAYCONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
NOT APPLY TO YOU.NOT APPLY TO YOU.
NOT APPLY TO YOU.NOT APPLY TO YOU.
NOT APPLY TO YOU.
HOW TO OBTAIN WARRANTY SERVICEHOW TO OBTAIN WARRANTY SERVICE
HOW TO OBTAIN WARRANTY SERVICEHOW TO OBTAIN WARRANTY SERVICE
HOW TO OBTAIN WARRANTY SERVICE
Warranty service can be obtained from a Riverside Pump Manufacturing Inc. dealer
or distributor authorized to make warranty repairs. If you need warranty service,
check first with the Riverside Pump Manufacturing dealer or distributor from whom
you purchased the Product, or call for the name and location of the nearest dealer
providing warranty service: 1-800-696-9005 or 1-843-537-5579.
Riverside Pump Manufacturing Inc. will not make any reimbursements for warranty
service, except to Riverside Pump Manufacturing Inc. dealers or distributors
authorized to make warranty repairs. You must present your sales receipt when
making any claim for warranty service.
This warranty gives you specific legal rights, and you may also have other rightsThis warranty gives you specific legal rights, and you may also have other rights
This warranty gives you specific legal rights, and you may also have other rightsThis warranty gives you specific legal rights, and you may also have other rights
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.which vary from state to state.
which vary from state to state.which vary from state to state.
which vary from state to state.
IMPELLER HOUSING
STRAIGHT EDGE
IMPELLER
.020" - .030"
(0.5mm - 0.8mm)